1. VOLUME: Use this control to adjust the output level of the monitor.

2. EXT. SPEAKER: Use this jack to connect the monitor to an external speaker cabinet. This 1/4" mono jack is wired in parallel with the monitor’s internal speakers, and will not disconnect them when used. You must use a cabinet with an impedance of at least 8 ohms. We recommend either Crate’s UFM-10P or UFM-12H.

3. POWER/LIMIT LED: This two-colorLED will glow green when the monitor is active and red when the internal limit circuit is triggered. The limit circuit holds the output at the amplifier’s peak, preventing distortion. If the LED stays red constantly, reduce the Volume control (#1).

4. LINE IN: Use this jack to feed your signal into the PFM-65. Use a standard 1/4" shielded cable to connect to the line level output (1v RMS max) from your mixer or preamp. This works well with the post-EQ Line Out from Crate’s PCM mixer or the Line Out from Crate’s APM-75.

5. LINE OUT: Use this jack to "daisy-chain" the PFM-65 to another powered monitor. This jack is wired in parallel to the Line In jack (#4).

6. POWER SWITCH: Use this switch to turn the monitor ON in the up position, OFF in the down position.

7. FUSE: This protects the monitor against damages caused by a faulty power source or signal overload conditions. If the fuse blows, replace it ONLY with the same size and type as listed below the fuseholder. If the fuse blows repeatedly check the voltage source; if it’s okay, contact your Crate dealer for possible service information.

8. AC LINE IN: Firmly connnect the female end of the supplied AC power cord into this receptacle. Then plug the male end of the power cord into a properly grounded AC outlet. NEVER ATTEMPT TO DEFEAT THE GROUND CONNECTION OF THE POWER CORD!